SPIDO COMBO-S1 Manuel Utilisateur page 14

EN
INSTALLATION
Assembly of the filter system
(Illustration 1)
Assemble the filter system at the
location where the pump finally will
be. The filter pump consists of the
following parts:
1. 90° connection bracket
2. Transparent cover
3. Clamping ring
4. Filter tank
5. Screw connection 0 32/38 mm
6. Bracket for filter pump
7. Filter pump
8. Connection hose 0 32 mm
Assembly of the filter system
(Illustration 2,3,4)
1. Open the clamping ring and remove
the transparent cover from the filter
tank.
2. Fill the filter tank with the filter balls
which are included with the order
(approx. 320g).
3. Now place the seal onto the
underside of the transparent cover.
4. Lay the transparent cover once
again onto the upper side of the filter
tank. lt is very important to ensure that
all surfaces have been cleaned once
again and are free from any dirt before
you do this.
5. The transparent cover is connected
to the filter tank using the clamping
ring. The clamping ring is screwed
together with the clamping ring screw
and clamping ring screw nut.
6. Fit the connection bracket on the
upper side of the transparent cover.
7. Finally, connect the connection
bracket with the filter pump. Fasten
all connections with hose clips and
ensure that the pump connecting
pieces are adequately sealed using
teflon tape.
Pump hose connections
(Illustration 5)
A: Return line - connection between
the filter tank and the connection to the
inlet nozzle (pool). The filtered water is
fed back into the pool at this point.
B: Skimmers - connection between
the skimmer connection (pool) and the
filter pump. The water that is going to
be cleaned is drawn in from the pool at
this point.
FILTER SYSTEM INSTAL-
LATION INSTRUCTIONS
• Once the filter system has been
properly assembled,
chamber filled with sand and the
hoses connected as described above,
you may begin with filtration.
• Do not plug the system in until
advised to do so below.
• Make certain the pump is not
plugged in to a power supply.
• Before operating the filter system,
il is important to ensure that the filter
system is positioned outside the pool
and is lower than the pool's water
level. The hose connections must also
be correctly connected and fastened.
• If you haven't done so already, fill
the sand