SPIDO COMBO-S1 Manuel Utilisateur page 13

EN
CHECK SCOPE
OF DELIVERY
NOTE! Risk of damage! The product
may be damaged if you open the
packaging with a sharp knife or other
sharp objects without due care and
attention. Please open the packaging
very carefully.
• Remove the product from the
packaging.
• Check that all included items have
been delivered in full. Sketch/photo L 1.
• Check whether the item, or parts
thereof, exhibit damage. If there is
da mage, do not use the product. Get
in contact with the service address
stated at the end of the manual.
OPERATION
The filter balls in the filter tank ensure
that dirt particles and floating debris are
effectively filtered over a long period
of time. Dirty water is drawn from the
pool via the suction pipe through the
filter pump and then fed from above
into the filter tank. As the water flows
through the filter balls in the filter tank,
dirt particles are deposited in the filter
balls and thus filtered out of the pool
water. The purified water then flows
through the return pipe back into the
pool.
For the operation of the filter system,
you need a skimmer (surface skim-
mer). Either an integrated skimmer
(built into the pool wall) or a suspended
skimmer (attachment to the poolwall).
POSITIONING
The installation area you set between
the skimmer and the inlet nozzle so,
that there is an adequate safety margin
to the pelvic wall. We recommend
putting the filter system in addition
on base plates (for example: washed
concrete slabs etc.). These have to
be installed with the spirit level. Under
no circumstances you may put your
filter system in a trough or directly
into the grass (flood danger or risk of
overheating of the filter pump ).
If you have sunk your pool partially or
completely, so it makes sense to place
the filter pump in a filter slot, which
should connect directly to the pelvis. is
your filter pump housed in a filter slot,
so it has to be insured, that the filter
slot can't be flooded. For this purpose
you should bring in a roller-bumishing
(crushed rock) in the range of the
filter slot, so that the surrounding- and
rainwater can seep away. lt would be
ideal if there is
a direct connection to the drain in
the sump of the filter shaft (or sludge
pump, with automatic floating switch).
Il is important to ensure that the
filter slot should never be airtight,
because this may cause damage,
due to condensation water, on the
filter pump. The size of the fil ter shaft
should be selected so that work can be
performed on the filter system.