Test Tone; Parental Lock; Setting The Parental Lock; To Change Parental Lock Settings - Rotel RDV-1080 Manuel De L'utilisateur

RDV-1080 DVD Audio/Video Player
DELAY Settings:
You can delay the signal from any of the speak-
ers in your system. The ideal is for the sound
from the front, rear, center, and subwoofer
speakers to reach your listening position at the
same time in order to reproduce surround sound
audio as it was recorded. Generally, you in-
crease the delay for speakers located close
to you and decrease the delay for speakers
located farther away.
• On the SPK. SETTING screen, use the
CURSOR buttons to move the
the DELAY field, then press the ENTER but-
ton. The DELAY field changes color to in-
dicate the delay settings can be adjusted.
• Use the CURSOR buttons to move the
over the speakers you wish to adjust:
F.SP: front speakers (delay is fixed at 0ms)
C.SP: center speaker (adjustable in 1ms
increments from 0ms to –5ms)
R.SP: rear speakers (selectable: 0ms,
–5ms, –10ms, and –15ms)
• Press the CURSOR buttons to change
the delay up or down.
• To exit the DELAY setting mode, use the CUR-
SOR buttons to move the
the DELAY field, and press ENTER. The
DELAY field changes to its original color.

Test Tone

To assist in the SPEAKER LEVEL setting proce-
dure, you can turn on a pink-noise test tone
signal. This signal makes it easier to hear the
relative volumes of the speakers or it can be
used with an SPL meter for more accurate setup.
To turn on the test tone feature, first make sure
that you are in the SPEAKER LEVEL mode.
• On the SPK. SETTING screen, use the
CURSOR buttons to move the
the TEST TONE field, then press the EN-
TER button. The field changes color and
the test tone begins, shifting from one
speaker to the next sequentially.
• When you move use the CURSOR
tons to move the over the speakers you
wish to adjust, the test tone signal shifts to
that speaker.
F.SP: front speakers
C.SP: center speaker
R.SP: rear speakers
S. WOOFER: subwoofer (no test tone)
• Press the CURSOR
the level up or down. You should hear the
test tone get louder or softer.
• To exit the LEVEL setting mode, use the CUR-
SOR buttons to move the
the TEST TONE field, and press ENTER.
The field changes back to its original color
and the test tone is turned off.
: The test tone is also available when
NOTE
setting the DELAY, however it serves no useful
purpose for this adjustment.
over

Parental Lock

The RDV-1080 has a Parental Lock feature to
prevent children from watching inappropriate
DVD Video discs. The feature relies on ratings
systems (specific to each country) that set a
rating level for discs starting from material
suitable for viewing by all children and in-
creasing as the subject matter becomes more
inappropriate for children. The Parental Lock
feature allows you to set the restriction any-
where from Level 1 to Level 8. A disc with a
rating higher than the specified level requires
entry of a password for playback. Thus, if you
specify a Level 5 restriction, any discs rated
back over
Level 6 or higher require a password.

Setting the Parental Lock

With playback stopped or no disc in the unit:
• Press STOP
simultaneously. The PARENTAL LOCK screen
appears on the TV with the
COUNTRY CODE field.
over
• Press the CURSOR
but- though the list of country codes and make
a selection. The codes can be found in Fig-
ure 5. Use the country whose standards
were used to rate your discs, generally the
country where you live.
• Press ENTER. The
field.
28
buttons to change
back over
and ENTER on the remote
over the
buttons to scroll
moves to the SET LEVEL
• Press the CURSOR
though the list of setting levels and make
a selection. The available options are:
NONE: no restriction
LEVEL 1: the most restrictive
LEVELS 2–7: progressively less restrictive
LEVEL 8: the least restrictive
• Press ENTER. The moves to the PASS-
WORD field.
• Enter a 4-digit password using the NU-
MERIC (0–9) buttons on the remote. If you
make a mistake, you can reenter a differ-
ent password. Write down your password
for safe keeping!
• Press ENTER. The moves to the EXIT field.
Press ENTER again to exit the Parental Lock
screen and return to the Opening Screen.
To Change Parental Lock
Settings
With playback stopped or no disc in the unit:
• Press STOP and ENTER on the remote
simultaneously. The PARENTAL LOCK screen
appears on the TV with the
PASSWORD field.
• Enter your 4-digit password using the NU-
MERIC (0–9) buttons on the remote. If you
enter the wrong password "Wrong! Re-
try...." appears on the screen and you
cannot proceed. If you enter it wrong more
than three times, "NO!" is displayed and
the jumps to EXIT field. If you enter the
correct password, the
COUNTRY CODE field.
: If you forget your password, enter the
NOTE
master password "8888".
• Press the CURSOR buttons to change
the COUNTY CODE, if desired.
• Press ENTER. The moves to the SET LEVEL
field.
• Press the CURSOR buttons to set the
desired LEVEL, if desired.
• Press ENTER. The moves to the PASS-
WORD field.
• If you want to change your password, enter
a new 4-digit password using the NUMERIC
(0–9) buttons on the remote. If not, enter
the old password.
buttons to scroll
over the
moves to the