Progress PKV1445 Notice D'utilisation page 34

34 Progress
Problem
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the tempera‐
ture.
The compressor does not
start immediately after
pressing the IntensiveCool‐
ing, or after changing the
temperature.
Water flows inside the refrig‐
erator.
Possible cause
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FastFreeze is switch‐
ed on.
The IntensiveCooling is
switched on.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
Solution
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor‐
ing.
Refer to "FastFreeze function".
Refer to "IntensiveCooling
function".
Position the water drainage
plug in the correct way.
Wrap the food products better.
Refer to "Operation" .
The compressor starts after a
period of time.
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.