Bort BSS-2400N Mode D'emploi page 9

MAINTENANCE
1. How to drop dust and clean the dust cup
Always operate the cleaner with dust cup installed.
1. Press the dust cup release button, handing the dust
cup handle, take off the dust cup from the vacuum
cleaner.
2. Press the dust cup bottom release button, then the
dust will full down automatically. Usually you may only
do like this to drop the dust.
3. If fi nd the plastic centre system too dirty, please
press the dust cup cover release button, take out the
fi lter assembly out of the dust cup, then you can clean
them with soft brush or wash them with water. You
should dry them completely before you use again.
2. Install dust cup on the body:
1. Pull the dust cup bottom back to the dust cup until
the button be locked.
2. Put the dust cup onto the body case properly.
3. Push on the dust cup to fi x with body.
4. Change or cleaning the inlet and exhaust HEPA fi lter
a. Push the dust cup release button, handing the dust
cup handle to rear side, take off the dust cup from the
vacuum cleaner. Draw out the inlet sponge and HEPA
fi lter set (Note: Please draw out the whole set with case
box.).
Pull up the knob of the fi lter frame, and pull out the
sponge fi lter and HEPA fi lter from the case box.
Cleaning the Sponge and HEPA fi lter by soft brush
or rinse it in lukewarm water and dry them completely
before use again. All the fi lters are washable. ( we
recommend you to clean the fi lters when feeling the
suction power becoming weak.)
For exhaust HEPA fi lter, press the button on the grid,
take out the grid out (at back of vacuum ).
Hand fi rmly and pull out the HEPA fi lter out .
Cleaning the HEPA fi lter by soft brush or rinse it in
lukewarm water and dry them completely before use
again. Or replace the HEPA fi lter with a new one.
This fi lter is also washable. ( we recommend you to
clean the exhaust HEPA fi lter at least one time every
3 months.)
Assemble the grid back to the body.
Note: The above fi lters should be equipped in correct
places when work the vacuum machine.
Change or cleaning the inlet and exhaust HEPA fi lter
b. Push the dust cup release button, handing the dust
cup handle to rear side, take off the dust cup from the
vacuum cleaner. Draw out the inlet sponge and HEPA
fi lter set (Note: Please draw out the whole set with case
box.).
Pull up the knob of the fi lter frame, and pull out the
sponge fi lter and HEPA fi lter from the case box.
Cleaning the Sponge and HEPA fi lter by soft brush
or rinse it in lukewarm water and dry them completely
before use again. All the fi lters are washable. ( we
recommend you to clean the fi lters when feeling the
suction power becoming weak.)
9