Setting The Time; Function Description - Zehnder Roda Twist Spa Air Mode D'emploi

EN

SeTTIng The TIme

The time can be set by following the procedure below:
o Make sure the remote control is switched on.
o Access the setting function by pressing and holding the P1 and P2 keys
together.
o The set time LED
o Set the time by pressing + or -. Press and hold the + or - key to speed up
the process.
o Once the time is set, wait approximately 10 seconds (or press the P1 or P2
key).
o The
rePLACIng The bATTerIeS
When the low battery indicator light
to replace them (2x 1.5V alkaline batteries, type LR03 or AAA; we advise
against using rechargeable batteries).
When the batteries are replaced, all the remote control parameters are saved
(for instance: P1 and P2 programming) except for the time setting.
You should take the following precautions:
- ensure correct +/– polarity;
- take care when disposing of used batteries: protect the environment by
disposing of them at an approved collection point.

3.1.2 function description

SWITChIng The remOTe COnTrOL On And Off:
You can switch the remote control on or off by pressing and holding the
nOTe:
Switching off the remote control will put the blower on stand-by.
34
is displayed and 00:00 blinks.
is no longer displayed and the time has been set.
is displayed, you have a few days
key.