SWITChIng The mAnUAL bOOST On And Off
Press the BOOST key to start the blower for a set amount of time (see chapter
3.3, parameter 0 to modify it).
Once the boost has started, you can adjust its operating time from between 15
to 120 minutes by pressing the + or - key repeatedly. You can stop it at any time simply
by pressing the BOOST key.
The
symbol is displayed throughout the
uration of the manual boost. The time remai-
ning will scroll across the display until the end
of the preset period.
nOTe:
The total continuous blower operating time cannot exceed 2 hours (i.e. 120
minutes). An automatic 30-minute pause is programmed after 2 hours of
continuous operation. After this pause, the blower restarts. This automatic
stopping does not modify the programme end time.
deSIred TemPerATUre AdjUSTmenT
You can adjust the desired setpoint temperature by
pressing the + or - key on your remote control within a range
of between 7 and 28°C.
The desired temperature adjustment is impossible when a manual boost is
in progress. If you wish to modify the temperature, stop the manual boost by
pressing the BOOST key. Then set the desired temperature and restart the
manual boost by pressing the BOOST key again.
dAILY PrOgrAmmeS P1 And P2
When activated, functions P1 and P2 allow you to run one or two automatic
programmes every day at the same time. The settings for P1 and P2 are independent.
EN
Use 35