Zehnder Roda Twist Spa Air Mode D'emploi page 43

bLOWer
Problem diagnosis
The LED is The blower is
blinking. overheating.
The blower
stops and does Timeout period.
not restart.
Loss of signal from
the remote control.
The blower
The blower is
does not start.
switched off.
Electricity supply
problem.
The FILTER There is no filter or
and LEDs it is positioned
are blinking. incorrectly.
After approximately
200 hours of use,
The FILTER the FILTER LED
LED lights up. lights up to indicate
the filter requires
cleaning.
Steps to take
• Switch the blower off at the
button, make sure the
ON LED is off.
• Make sure there is no towel
or other item blocking the air
circulation in the blower.
• Check the condition
of the filter and clean it if
necessary.
• Reposition the filter
correctly in its housing.
Allow the blower to cool
down.
Move the remote control.
Press the button on
the blower.
Check the electrical
installation.
• Reposition the cleaned
filter correctly in its seat,
the FILTER LED will then
be turned off.
• Hold down the button
for 5 seconds to reset it and
check that the LED is off.
• Turn off the blower at the
button.
• Pull out the filter situated at
the rear of the blower (see
above) and wash it in warm
water or clean it with a
vacuum cleaner.
• Reposition the filter, making
sure the grille is facing up.
restarting
• Wait a few minutes then
press and hold the
button for 5 seconds to
reset the blower.
• Switch the blower back on
and make sure the
is off. The blower is now
ready to receive instructions
from the remote control to
restart (see chapter 3.1).
See chapter 3.1.2
Test the reception.
The blower is now ready
to receive instructions from
the remote control to start
(see chapter 3.1).
After cleaning, you will
have to reset the blower
by holding the
down for 5 seconds.
Maintenance and troubleshooting tips 43
EN
LED
button