Electronic Lock; Reset To Factory Settings; Advanced Functions; Setting The Day - Zehnder Alura LCD Manuel

3.6 Electronic lock

EN
This function prevents unwanted operation of the control panel.
When it is activated, unintentional mode or desired temperature level
changes are not possible.
To activate this function, press the – and + keys together for 5 seconds then
release when the lock indicator
The indicator stays on. If any of the keys are touched again, this indicator
will blink twice to inform you that the lock is active.
To deactivate this function, press the – and + keys together for 5 seconds. The
control panel is now unlocked and the lock indicator disappears.
NOTE:
Mode changes made by a pilot wire base unit (not supplied with your appliance)
will not be deactivated by this function.

3.7 reset to factory settings

ImPOrTANT When your control panel is unlocked, you can return to the original
settings at any time by pressing and holding the RESET key for 5 seconds. The
default user programme (ECO mode) is reactivated and calibration reset to zero.
Your display will successively show "--" then "88 8" before returning to its original
parameters (see chapter 3.1).
3.8 Stopping the heating
Pressing the key for 2 seconds stops your appliance heating up. The
appliance then emits two audible signals.
ThE rADIATOr DOES NOT hEAT.
40
appears.

4. Advanced functions

Press and hold the MODE key for 5 seconds (except from the User Programme
) to access the radiator's advanced functions as described below. The
will blink while you browse these functions.
Browsing these functions is possible by pressing the MODE key repeatedly.
Each time the key is pressed moves you to the next setting and confirms the modifica-
tions made.
You can quit the advanced functions menu at any time by pressing and holding
the MODE key for 5 seconds or waiting for one minute without pressing any key.
The indicator will then stop blinking.

4.1 Setting the day

Refer to the introduction to this chapter to access the functions menu and how
to browse them.
The clock indicator
screen displays the number of the day. Set the day by pressing the –
or + keys (for instance, assuming that Monday = day 1).
Briefly press MODE to move to setting the time.

4.2 Setting the time

Refer to the introduction to this chapter to access the functions menu and how
to browse them.
The clock indicator
hour by pressing the – or + key.
Press MODE briefly to move on to the minutes setting.
In the same way you set the hour, press the – or + key to set
the minutes.
40008126 40008126
is displayed without blinking. The
is displayed without blinking. Set the
EN
indicator
Advanced functions 41