MRA 4025066169542 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
1 pair of holders
4 Elastic nuts M5
8 Plastic discs 12x5x0.5mm
2 Fillister head screws, black M5x16mm
2 Distance sleeves 6mm
6 O-rings, 4.5x1.5
6 Fillister head screws, M5x20mm
4 Distance sleeves 3mm
1 Protective edge strip with clamping sleeves
How to mount the screen on your motorbike:
1. Place the motorcycle on a flat surface.
2. Dismantle the speedometer cover (P1).
3. Take the provided retaining plates [11442] and insert the M5X20mm filister head screws with the
plastic washers in the lower holes.
4. Place the provided 6mm spacer pieces [11038] against these from behind and secure them with the
O-rings provided [10992] (P2).
5. Mount the retaining plates using the provided M5X16mm fillister head screws [10554] and the
plastic washers [10635] onto the motorcycle (upper holes).
6. Tighten both screws (upper hole / lower hole) equally. When the retaining plates are in the correct
position, tighten the screws and insert the provided rubber nuts [10629] into the holes (P3).
7. When the retaining plates are mounted, insert the M5X20mm fillister head screws [10673] with the
plastic washers [10635] into the holes on the MRA windscreen. Push the 3mm spacer pieces [10872]
against these from behind and secure them with the provided O-rings [10992] (P4).
8. Mount the MRA windscreen to the motorcycle and tighten the fastening screws.
Pull the provided edge protection onto the windscreen as shown in figure 4.
9. Push the clamping sleeves over the ends of the protective edge strip profile and lightly press these
together using a pair of pliers to secure the protective edge strip profile.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 E-Mail: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
BMW F900R 2020-
Article No..
--- Torx TX 25
Allen key 3mm
11442
10629
10635
10554
11038
10992
10673
10872
---
3
Required tools