Güde ISG 1200 ECO Traduction Du Mode D'emploi D'origine page 30

Air filter
The air filter should be cleaned every 50 hours of operation.
Release the bolt and remove the cover.
Release the air filter cover bolt.
Remove the air filter cover.
Check the external and main filter and wash it in non-
flammable or little flammable solvent and let it dry out if
necessary.
Drop small amount of oil on the air filter and press it.
Refit the filter.
Fasten the air filter cover bolt.
Tighten the cover and the cover bolt.
The appliance must never be used without the air
filter as it could quickly wear the engine out.
Spark plug
Remove the servicing cover off the spark plug.
Remove the socket plug.
Remove any dirt and dust off the bottom of the spark
plug.
Using the spark plug spanner, screw the spark plug
out.
Check the spark plug for any cracks and scratches. If
the spark plug has any sign of damage, dispose it
immediately.
If the spark plug can still be used, clean it by a wire
brush.
Now check the distance of electrodes by a feeler
gauge. Bend the side electrode and provide the proper
distance (proper distance: 0.6 to 0.7 mm).
Refit the spark plug.
Refit the socket plug on the spark plug.
Refit the servicing cover.
Oil change
Engine oil to be discharged when the engine is warmed up
to make sure it is emptied quickly and to the full extent.
Before discharging, make sure the fuel tank cap
ventilation lever is in the OFF position.
Release the cover bolt.
Remove the left cover.
Remove the oil tank cap
Discharge the engine oil to an appropriate container
Add the recommended engine oil (SAE 10W-40) and
check the engine oil level
Fit the oil tank cap.
Refit the cover and tighten the bolt
After coming into contact with the waste oil, hands should
be thoroughly washed with water and soap.
Please observe the applicable environment
protection provisions when disposing the waste oil. We
recommend taking the waste oil to a waste oil collection
centre in a closed vessel. Do not put the engine oil to waste
and do not pour it on the ground.
Noise suppressor check
Let the noise suppressor cool down before any
servicing.
The spark catcher must be checked every 100 hours
of operation to make sure it works perfectly.
Remove the four bolts and the cover.
Now remove the three 6-mm bolts, then the noise
suppressor, spark catcher and sealing.
Clean the spark catcher by a steel brush. Check the noise
suppressor sealing and spark catcher for any holes and
cracks. If the spark catcher or sealing is damaged, it must
be replaced.
Refit the parts in a reversed order.
Refuelling
Never refuel when the appliance is running. After using the
appliance, let it cool down for at least 5 minutes before
refuelling.
Fuel: Unleaded petrol
Never smoke near the appliance and fuel. Never refuel near
sparks, flames or open fire.
Important: remove any cables
Open the fuel tank cap
Add carefully fuel to the filling opening.
At all times, refuel the tank not more than up to
the maximum marking
Refit the cap to the filling opening.
Service
Any technical questions? Complaint? Do you need spare
parts or operation manual?
Go to our website www.guede.com and the section Service
will help you quickly and without bureaucracy. Please, help us
to help you. In order to identify your device in case of complaint,
please indicate serial number, order number and year of
manufacture. All information is available on the product label.
To have all information always at hand, put them down.
Serial number:
Order number:
Year of manufacture:
Phone:
Fax:
E-Mail:
24
+49 (0) 79 04 / 700-360
+49 (0) 79 04 / 700-51999
support@ts.guede.com