Preparation; Basic Settings - Bosch MUM9 OptiMUM Série Mode D'emploi

en

Preparation

Cable storage
compartment
X Fig. A
Depending on the model: The
appliance is equipped with a cable storage
compartment. The length of the power cord
can be adjusted as required by pulling it out
or pushing it back.
Safety systems
The appliance features various safety
systems. X "Safety systems" see
page 36
Preparation
■ Place the base unit on a smooth, clean
and stable surface.
■ Pull the power cord out to the required
length.
■ Press the release button and raise
the swivel arm to the stop.
■ Place the cover with the filling shaft at
the front on the main drive.
■ Insert the bowl. When doing so, use the
recesses on the base unit.
■ Turn the bowl anticlockwise until it locks
into place.
The base unit is prepared for further use.

Basic settings

Setting the display language
■ Press the release button and push the
swivel arm down until it locks into place.
■ Plug the mains plug into the mains.
■ "OptiMUM" appears on the display.
Note: If the appliance is not used or
operated within a certain period, the display
will slowly fade and switch to standby
mode. "OptiMUM" will appear once again
when any button is touched.
■ Press and hold buttons A and + at the
same time until the configuration menu
is opened. The language selection is
shown.
28
■ Press the button + or - repeatedly
until the desired language is displayed.
LANGUAGE
ENGLISH
■ Press and hold buttons A and +
simultaneously until "SAVED ENGLISH"
appears on the display. The language
selection is saved.
SAVED
ENGLISH
■ If no further setting is made, "OptiMUM"
appears again on the display.
Additional settings
■ Press and hold buttons A and + at the
same time until the configuration menu
is opened.
■ The following settings appear in
sequence each time button A is briefly
pressed:
– LANGUAGE
Language in which the display texts are
displayed.
– SOUND
Volume of the acoustic signals – setting
in 6 levels from off to loud.
– BRIGHTNESS
Brightness of the display – setting in
6 levels from dark to bright.
– UNITS (for models with scales)
Unit of display for the scales – grams (g)
or pounds (lb).
■ The current setting is changed using the
button + or -.
■ Press and hold buttons A and +
simultaneously until "SAVED" appears
on the display. The changed settings are
saved.