Fracarro SIG9708CI Instructions D'emploi page 29

Programming the input transponder. Set the LNB, IF frequency, and choose the specific channel within
the selected transponder. Pre-memorized channels can also be programmed by selecting them from
the presets list. See Presets list on page 5.
INPUT
Set remote power
for LNB
Set the DiSEqC tone
Reading the frequency of
the local oscillator
IF frequency of the
transponder
to be received
Symbol rate of the
transponder
to be received
FEC of the transponder
to be received
List of available
programs
4.7 INPUT
Selezione di un canale
prememorizzato
PRESET OFF
LNB OFF
DiSEqC A
OL FREQ. (MHz)
IF FREQ. (MHz)
SYMBOL RATE
FEC AUTO
SERVICE LIST 1/N PROGRAM 1
SERVICE PROPR. PROGRAM NAME
TELETEXT PID
SUBHEADINGS
SERVICE TYPE
AUDIO TYPE IN
(confirm the setting by pressing the
by pressing the S key after the modules programmation)
PRESET 1
Enter with
LOAD PRESET
SAVE PRESET
18V/22KHz
satellite A
satellite B
D satellite C
satellite D
Read-only
AUTO
Increase/decrease by T PE arrows or enter
950 2150
1000 45000
Read-only
N/N PROGRAM N
Name of the selected
program
ID Service of the selected
SERVICE ID
program
PID PCR of the selected PID PCR
PCR PID
program
Video PID of the selected Video PID
VIDEO PID
program
Audio PID of the selected Audio PID
AUDIO PID
program
Teletext PID of the Teletext PID
selected program
Subheadings selection
Type of the selected
Type
program
Video Format of the
FORMAT
selected program
Audio Audio type of the type
selected program
¸
key; save the settings
9
PRESET 10
Enter with
Loading ...
OFF
14V/0KHz
18V/0KHz
14V/22KHz
18V/22KHz
the value directly by the digit keyboard.
Increase/decrease by T PE arrows or enter
the value directly by the digit keyboard.
"Not available": transponder
not locked.
"NONE": ID service not
present
Enter value by
TPE digit keyword
Increase/decrease with the
arrows of the TPE keyboard.
Increase/decrease with the
arrows of the TPE keyboard.