Programming Instructions - Fracarro SIG9708CI Instructions D'emploi

card modulates the external signal at the RF output.
The two SUB-D15 pin connectors are supplied with an audio and video regulation at the input. This
variation occurs by way of two trimmers placed on the front of each card (see Figure 15).
output audio
adjustment
green led
red led
output video
adjustment
flat cable
connector
NOTE: when the boards 7 and 8 are used in modulator mode, the red LED will flash.
3.2 INSERT THE CAM IN THE SLOT COMMON INTERFACE
To insert and remove the CAM from the slot common interface of a Master or Stand-alone receiver, open
the headend front panel with the key and insert/remove the CAM (not supplied) in the slot common
interface in the bottom part of the receiver. Refer to Figure 6 and 7.
ATTENTION: when you use the CAM (not supplied), take note of the maximum operating
temperature declared by the manufacturer.
WARNING: scrolling the channel list the "encrypted program" message might be displayed, even if you
own the decoding rights. Wait a few seconds and the display and decoding will continue automatically
(the video display wait is directly dependent from the CAM).
WARNING: a few functions of the CAM are accessible only after they are enabled. For further information
see the CAM menu (menu: COMMON INTERFACE – CI MENU).
To program and display the internal status of the headend, use a TPE programmer. Each receiver must
be singularly programmed by setting all the parameters that single out the SAT program in the input and
define the output channel (in the VHF or UHF band). Connect the programmer to one of the two RJ45
plugs (see Fig. 1), (please wait a few seconds, TPE searching line of device, when the TPE arrive to the
number of receivers press
shows the Fracarro logo. Press any key of the keyboard (except the
FRONT VIEW OF RECEIVER
audio left
audio right
video
Fig. 15 Selection of SAT receiver mode or modulator

4. PROGRAMMING INSTRUCTIONS

key), to enter all the receivers; the TPE switches on automatically and
Selection
SUB-D
15 pin
EXT
audio
left
SAT
EXT
audio
right
ONLY FOR SAT
MODULE
EXT
video
n° 7 & n° 8
SAT
selection
EXT
audio
Audio & Video
left
SAT
IN/OUT
EXT
audio
right
SAT
EXT
video
SAT
key).

SAT
RECEIVER
MODE
MODULATOR
MODE