Hydrotechnik SEG 1060 Mode D'emploi page 52

: Display range exceeded
Possible cause of error:
x
Wrong scaling
Possible remedy:
x
Error message is resetted automatically, when input signal is < 9999
again
x
Possibly the display range is too big cause of scaling and should be
reduced (e.g. divide by 10)
: Fall below display range
Possible cause of error:
x
Wrong scaling
Mögliche Abhilfe:
x
Error message will be resetted automatically, when display value is
within allowed borders again.
x
Possibly the display range is too small cause of scaling and should be
enlarged (e.g. factor 10)
: System error
Possible cause of error:
x
Outside allowed operating temperature range.
x
Instrument defective
Possible remedy:
x
Maintain allowed operating temperature range
x
Use different instrument
: Value could not be calculated
Possible cause of error:
x
Wrong scaling
Possible remedy:
x
Check settings and input signal
: Invalid value / wrong configuration
Possible cause of error:
x
Wrong instrument configuration
Possible remedy:
x
Check configuration
© Hydrotechnik GmbH • All rights reserved 23