Hydrotechnik SEG 1060 Mode D'emploi page 43

SEG 1060
Instructions for use
11.
input signal = 20 mA / 10 V.
12. –
13. –
14.
15. –
16. –
17.
0.01 to 2.00 seconds.
18. –
19. –
20, – leave configuration menu.
* 1 exceeding the range limits is allowed up to the measurement border
(see also following hint).
* 2 the Measurement Range is strictly limited to the input signal values; if
the range limits are exceeded, an Error Message is displayed.
* 3 the Measurement Range is strictly limited to the input signal values; if
the range limits are exceeded, the relevant range limit is displayed.
Hint
If the measurement limits (upper measurement range limit +10%) are
exceeded, error message
the limit setting. If the measurement limits (lower measurement range -
10%) are fallen below, error message
signal „4 – 20 mA" independant of the limit setting. Falling below 0 V or 0
mA will not be recognized.
4.4.4 Configure frequency measuring
You have set measurement type
1.
2.
3. –
14
set display value that shall be displayed at
.
.
select measurement range limitation:
= disabled* 1
= active (error indication)*
= active (display measurement range limitation)*
.
.
set filter (digital simulation of a low-pass filter): OFF or range
.
.
– – .
select input signal:
= TTL-signal
= switch contact, NPN*
= switch contact, PNP*
.
2
will always be displayed independant of
will be displayed at input
.
1
2
3
Version 1.2