Hydrotechnik SEG 1060 Mode D'emploi page 42

Possible input signals
Type of meas.
Voltage signal
Current signal
Frequency
Flow rate
Number of revs
Please take note:
If a new measurement is set, all existing values are removed. These must
be re-programmed when and as required.
Changing the Type of Measurement and other parameters can affect the
Offset and Gradient correction values, as well as those of the Switch and
Alarm settings. Check these parameters after a change in the Type of
Measurement.
4.4.3 Configure voltage and current measurement
You have set meas. type
1.
2.
3. –
4. –
5.
6. –
7. –
8.
input signal = 0 mA / 4 mA / 0 V.
9. –
10. –
© Hydrotechnik GmbH • All rights reserved
Input signal
0 – 10 V
4 – 20 mA
0 – 20 mA
TTL-signal
switch contact NPN, PNP
PNP
TTL-signal
switch contact NPN, PNP
– – .
select input signal:
= voltage measurement 0 – 10 V
= current measurement 4 – 20 mA
= current measurement 0 – 20 mA
.
.
set decimal point position.
.
.
set display value that shall be displayed at
.
.
or .
Display go to
4.4.3
4.4.3
4.4.4
4.4.5
4.4.6
13