Hydrotechnik SEG 1060 Mode D'emploi page 45

SEG 1060
Instructions for use
* 5 Measuring range limited to measured frequency borders; correspon-
ding border is displayed when borders are exceeded/fallen below.
Hint
Independant from the limit setting, error message
displayed when max. measured frequency border (10 kHz) is exceeded.
4.4.5 Configure flow rate measurement
You have set measurement type
1.
2.
3. –
4. –
5.
6. –
7. –
8.
range 0.01 to 2.00 seconds.
9. –
* 1 For the direct connection of a transducer with PNP-output; pull-down
resistor integrated in the instrument; an additional resistor is required
at frequencies > 2 kHz.
* 2 You can find the calibration value in the calibration protocol of the low
rate sensor.
4.4.6 Configure speed measurement
You have set measurement type
1.
2.
3. –
4. –
5.
sends per revolution.
6. –
7. –
16
– – .
set decimal point position.
.
.
set calibration value of flow rate sensor.*
.
.
set filter (digital simulation of a low-pass filter) OFF or in the
.
– – .
select input signal:
= TTL-signal
= switch contact, NPN*
= switch contact, PNP*
.
.
enter pre-divider; this is the number of impulses the transducer
.
.
(always PNP).*
2
.
1
2
will always be
1
Version 1.2