Selve i-R Marki Send WS Notice D'utilisation page 37

Procedure for initial installation
3. The values for the wind and sun can be set via the potentio-
meters under the battery cover of the i-R Marki Send WS.
4. Testing the functions:
The sunshade function only starts from the upper limit position!
Put the receiver into TEST MODE for 5 minutes by pressing the
STOP button for 6 seconds. Cancel this via the Manual/auto-
matic sliding switch (AUTO–MAN–AUTO). The delay periods
are 60 times quicker in test mode than in normal mode.
If the light threshold value is exceeded, the system is extended
in TEST MODE after 3 seconds. If the threshold is not achieved,
the awning is retracted again after 15 seconds.
The wind function can be tested by rotating the wind wheel, but
only if small wind values (level 1–2) have been set!
Programming the i-R Marki Send WS
Note: Before programming the radio, check whether the wind
threshold control switch has been set to a small value (left limit
stop).
When programming the radio, ensure that you are not in the move-
ment area of the sun protection system.
Please also observe the operating instructions of the receiver and
other transmitters.
Only one i-R Marki Send WS or i-R Marki Send Plus can be pro-
grammed into the receiver at the same time. If you try to program
a second i-R Marki Send WS or i-R Marki Send Plus in the receiver,
the first one is immediately deprogrammed.
37
GB