Troubleshooting - Selve i-R Marki Send WS Notice D'utilisation

Troubleshooting

Troubleshooting
Problem
Drive is not functioning,
trans mission control light is
not lit
Drive is not functioning,
trans mission control light is
lit
Transmission control light is
flashing
The automatic switching
commands are not executed
The system is not extended
automatically when the
sliding switch is set to
'Auto'
The system extends manu-
ally for just 2 sec. and
immediately retracts with
sliding switch setting 'Man'
or 'Auto'
The system extends manu-
ally for just 4 sec. and
immediately retracts with
sliding switch setting 'Man'
or 'Auto'
Cause
Batteries are dead
Batteries are incorrectly
inserted
Receiver outside the radio
range
Transmitter is not pro-
grammed in the receiver
Batteries are running out
The sliding switch is on
manual
Sunlight intensity is below
the threshold value
Wind speed exceeds the
threshold value
The curtain is not in the
upper end limit
The intermediate position is
in the upper end limit
Wind speed exceeds the
threshold value
The Radio link between the
sensor and the receiver has
been interrupted; check the
transmission path by actua-
ting the UP/STOP/DOWN
button at the sensor
45
Solution
Insert new batteries
Insert batteries correctly
Reduce distance to the
receiver
Programme transmitter
Insert new batteries
Move the sliding switch to
automatic
Adjust sun threshold value
Wait until wind abates
Manually move the awning
to the upper end limit
Reprogram the intermediate
position
Wait until wind abates
(min. 15 minutes)
Re-establish the radio link
Check power supply to the
sensor
Reduce distance between
the sensor and receiver
GB