Desoutter EAB15-900 Mode D'emploi page 84

6159930390_05
Nº Mensagem
045 Anormal battery voltage
046 Anormal battery current
Anormal battery
047
behaviour
048 Battery type not allowed
205 Torque settings
206 Speed settings
210 Invalid Pset selected
211 Invalid trigger conf
212 Result not stored
216 Current high
223 Drive init error
224 IGBT too hot
227 Motor stalled
228 Drive err.
251 No Pset selected
Quando este ícone aparecer e soar a
mensagem de voz "Hardware failure"
ao ligar, solicite suporte de seu
representante Desoutter.
Solução
1- Anormal battery high voltage, check your battery.
2- This error can due to charger malfunction or end of life battery.
1- Anormal battery current consumption, check your PSet
settings.
2- This error can due to speed settings.
1- Anormal battery behaviour, check your battery.
2- If the problem occured again, change the battery with a new
one.
1- Battery type not allowed.
2- Change your battery type or your configuration.
1-Invalid Torque setting, torque is greater than tool characteristics
2-Check Pset settings with the current tool characteristics
1-Invalid speed setting, speed is greater than tool characteristics
2-Check Pset settings with the tool max. speed.
1- The Pset currently selected does not match the selectable one
in the Assembly Process.
1- The tool currently connected to the CVI3 is not equipped with
the trigger required by the tool trigger configuration
2- Adjust your tool trigger configuration to the tool connected or
change the tool according to the expected trigger configuration
1- It was not possible to persist the tightening result in the
controller
2- Contact your Desoutter representative for support
1-Max current exceeded.
2-Contact your Desoutter representative for support
1- Software failure.
2- Restart the controller.
3- If the problem occurs again, contact your Desoutter
representative for support.
1- Power electronics too warm.
2- Let the controller cool down.
1- Motor stalled (could be missing phase, wrong motortune or
power electronics failure)
2- Try once again, if the problem occurs again, contact your
Desoutter representative for support.
1- Software failure
2- Restart the controller.
3- If the problem occurs again, contact your Desoutter
representative for support
1- No Pset is selected
2- Select a Pset before start order
84 / 108 84 / 108
Português
(Portuguese)
04/2014 04/2014