Resetting To Factory Settings; Tool Recognition And Overload Limiting; Equipotential Bonding - Weller WT 1 Mode D'emploi

Resetting to factory settings

When switching on: Press and hold Exit, UP and DOWN for three seconds

Tool recognition and overload limiting

The WT 1 and WT 1H have automatic tool recognition which assigns the relevant control parameters to the connected tool.
To prevent overloading a station, only compatible tools are supported:
WT 1 max. 90 W:
WSP 80, WP 80, WTP 90, WP 65, WST 82, WSB 80, WHP 80, WTA 50, LR 21, MPR 80, WMP, FE 75
WT 1H max. 150 W (200 W):
WSP 80, WP 80, WTP 90, WP 120, WSP 150, WP 200*,
WP 65, WST 80, WSB 80, WSB 150, WHP 80, WTA 50, LR 21, MPR 80, WMP, FE 75
*Maximum power 150 Watt

Equipotential bonding

a
b
c
d
3
sec
Four variants are possible by connecting the 3.5 mm jack socket differently:
a Hard-grounded
b Equipotential bonding
c Floating
d Soft-grounded
supplied without plug.
with plug, equaliser at centre contact.
with plug
with plug and soldered resistor. Grounded through
selected resistor.
GB
ENGLISH
15