Analog way OCTRO-QUATTRO OTR401 Manuel Utilisateur page 27

OCTO-QUATTRO™
8-4. COMMANDS AND RESPONSES TABLE (continued)
ASCII
RESPONSE
COMMAND
COMMUNICATION PORT COMMANDS
ne LANE
nr LANR
ns LANS
na ADIP
nw IPA_
nx IPB_
ny IPC_
nz IPD_
np PORT
nk NTMK
nt TCP
OTHERS COMMANDS
M STO
R REC
? DEV
# DEV......
NOTE: Rd/Wr = Read and write command.
COMMAND
DESCRIPTION
Communication port selection
Reset of the LAN parameters.
Store the LAN parameters.
IP address and port selection (for
modification)
First byte of the address selected by the
na command.
Second byte of the address selected by
the na command.
Third byte of the address selected by the
na command.
Forth byte of the address selected by the
na command.
Number of the port (local or remote)
selected by the na command.
Netmask.
Protocol selection.
Image parameters storing.
RECALL: Recall the image parameters. Rd/Wr
Device type.
Send all device parameters.
Chapter 8 : REMOTE CONTROL PROGRAMMER'S GUIDE (continued)
TYPE
MIN MAX
Rd/Wr 0 1 0 = RS232
Rd/Wr 0 1 1 = reset.
Rd/Wr 0 1 1 = store.
0 = all IP address / ports
1 = IP local address / local port
Rd/Wr 0 3
2 = IP remote address / remote port
3 = IP gateway address.
Rd/Wr 0 255
Rd/Wr 0 255
Rd/Wr 0 255
Rd/Wr 0 255
local port: 10000 to 10999.
Rd/Wr 0 65500
remote port: 0 to 65500.
Value = number of bit to 0 (from right).
example: 2
Rd/Wr 0 24
Rd/Wr 0 1 0 = UDP
Rd/Wr 0 1 1 = STORE action (automatic reset).
0 1 1 = RECALL action (automatic reset).
0 65535 26 = OTR401.
Rd
Rd
Rd = Read only command.
VALUE
DESCRIPTION
1 = LAN
255.255.255.252
3 255.255.255.248
.............
8 255.255.255.0
.............
24 255.0.0.0
1 = TCP
PAGE 27