Displaying Various Data; Menu Screen - Sony DSR-25 Mode D'emploi

Displaying Various Data

The unit can display various superimposed data items
on the built-in LCD monitor or on a monitor connected
to the S VIDEO or VIDEO connectors in OUTPUT.
To display various data items on the LCD monitor, set
the CHARACTER DISPLAY (LCD) selector to ON or
ON (BLACK BACK).
To display various data items on an external monitor,
set the CHARACTER DISPLAY switch to ON.
You can select data items to be displayed using the
DISPLAY SELECT selector.

Menu screen

To display the menu screen, set the DISPLAY
SELECT selector to MENU. You can change or
confirm the menu item settings on this screen.
For details on the menu, see "Chapter 5 Adjusting and
Setting Through Menus" on page 54 (GB).
TC ⁄ UB SET
TC PRESET
TC
UB PRESET
CM
DV IN TC
DISP
TC MAKE
V
TC RUN
A
TC FORMAT
VTR
ETC
Data screen
To display the data screen, set the DISPLAY SELECT
selector to DATA. You can confirm important
information for recording or playback, such as time
code or remaining tape time, on this screen.
2
1
N
%Z
DEW
DETECTED
3
4
0 0 :1 2: 3 4: 12
TC
122min
5,6
PHOTO – 10
SEARCH
7
8
DVCAM
NS 4 8K
9
DV I N
q;
qa
1 Cassette memory indicator
This item is shown when a cassette with cassette
memory has been loaded. If the cassette is ejected
while data is being written on the cassette memory, the
indicator flashes.
2 Tape transport mode indicator
Displays the tape transport mode.
3 Time counter (time code/user bits/count value of
the counter) indicator
Displays the count value of the counter, time code, or
user bits. By setting the COUNTER SELECT selector
on the front panel, you can select the item to be
displayed.
When the time code is displayed,
In the drop frame mode, a period is displayed between
the minutes and seconds. (Example: 00:12.58:00)
When the user bits are displayed,
left.
When the count value of the counter is negative, "–"
appears as the first digit (leftmost digit). When that
value is positive, the first digit is blank.
The count value of the counter consists of seven digits.
If the self-diagnostic function is enabled, diagnostics
code numbers are displayed.
Notes
• The counter operates on a ±12-hour cycle. You
cannot make the counter operate on a 24-hour cycle.
• The count value of the counter consists of seven
digits. The leftmost digit is not displayed. (i.e.; If the
actual count value is "11:22:11:22," the displayed
value will be "1:22:11:22." ) However, the unit
recognizes that the hours value is 11.
4 Remaining tape time indicator
Displays the remaining tape time.
Note
When you insert a cassette in which the tape has been
rewound to the beginning, this indicator will not show
the remaining tape time. The remaining tape time is
displayed after the tape runs for a while.
5 Search indicator
Displays the search mode when you search for scenes
using the Remote Commander or the DSRM-20 (not
supplied).
For details on the search function, see "Searching using the
search function" on page 33 (GB).
appears to its left.
TC
appears to their
UB
(Continued)
23
Chapter 1 Overview (GB)