Sony DSR-25 Mode D'emploi page 53

8
Adjust the recording level by turning the AUDIO
REC LEVEL control knobs.
You can adjust the recording level with the
AUDIO REC LEVEL control knobs if you have
selected VAR in step 7. While looking at the audio
level meters on the LCD monitor, turn the AUDIO
REC LEVEL control knobs and adjust the
recording level. Adjust the audio recording level so
that the recording level does not exceed 0 dB when
the audio signal is at its maximum. If the recording
level exceeds 0 dB, the sound will be distorted.
9
Press the PAUSE button.
The PAUSE indicator goes off and audio dubbing
starts.
To pause audio dubbing
Press the PAUSE button.
Pressing the PAUSE button again resumes audio
dubbing.
To stop audio dubbing
Press the STOP button.
To monitor the sound you want
Set the AUDIO OUTPUT SELECT selector as
follows:
CH-1/2: You can listen to sound recorded on
channels 1/2 on the tape.
CH-3/4: You can listen to sound to be dubbed on
channels 3/4.
MIX: You can listen to the sound on the tape and the
dubbed sound.
For details on the audio levels display in the audio dubbing
mode, see page 24 (GB).
Notes
• You can monitor the sound on the tape while dubbing
the sound. However, there are some delays between
the sound being recorded and the sound being played.
When you play back the tape after audio dubbing,
you might hear the dubbed sound later than the sound
monitored during audio dubbing.
• You cannot dub sounds onto a blank portion of the
tape.
Chapter 4 Duplication and Audio Dubbing
53
(GB)