Disconnecting/Reconnecting - Bosch BCR1 Mode D'emploi

Home Connect
e
22
23
e) The functions of the robot vacuum can now be used in
full via the app on the mobile device.

Disconnecting/reconnecting

You can disconnect the robot vacuum from your wire-
less local area network at any time.
Note
If the robot vacuum is disconnected from your wireless
local area network, you will not be able to control it via
Home Connect.
23
Fig.
Press the "Wireless network" button (which will be
lit white or green) on the control panel twice within
1 second.
The "Wireless network" button will go out after ap-
proximately 2 seconds, indicating that the robot vac-
uum has been disconnected from the wireless local
area network.
Pressing the "Wireless network" button again will
reactivate the vacuum robot's wireless networking
function. If the robot vacuum was connected to a
wireless local area network before, it will reconnect
to this network.
Note
The wireless local area network information will be re-
tained indefinitely unless the robot vacuum is restored
to its factory settings.
en
89