Bosch BCR1 Mode D'emploi page 87

Home Connect
a
21
b
c
d
e
Connecting to a wireless local area network automa-
tically
Note
If your router has WPS functionality, please connect the
robot vacuum to your wireless local area network as
described here.
21
Fig.
Deactivate mobile data and activate wireless net-
working on your mobile device.
a) Connect your mobile device to your home network.
b) Press and hold the "Wireless network" button for at
least 3 seconds until the the button flashes blue.
Press the WPS button on your router within the next 2
minutes.
Wait until the "Wireless network" button lights up
green and three beeps indicate that connection has
been successful.
c) Open the Home Connect app and select [Add appli-
ance].
Alternatively, a small pop-up will appear showing the
robot vacuum.
If this happens, select [Add].
If prompted to, confirm the important information
shown in the app and select [Next].
Wait for the app to check the requirements for con-
necting the appliance.
If you did not already do so in the pop-up at point
c), now select the robot vacuum you want to connect
using [+].
If the Home Connect app requires confirmation on
the appliance, briefly press the "Wireless network"
button on your robot vacuum.
d) The robot vacuum will connect to the app.
Select [Next].
Set the time function you want in the app and confirm
with [Done].
e) The functions of the robot vacuum can now be used
in full via the app on the mobile device.
en
87