Bosch BCR1 Mode D'emploi page 88

Home Connect
a
22
b
c
d
88
Connecting to a wireless local area network manually
Note
The robot vacuum sets up its own wireless local area
network for the end device to access.
22
Fig.
Deactivate mobile data and activate wireless net-
working on your mobile device.
a) Connect your mobile device to your home network.
b) Open the Home Connect app and select [Add appli-
ance].
Confirm the important information shown in the app
and select [Next].
Wait for the app to check the requirements for con-
necting the appliance.
If you have added other Home Connect appliances to
your home network already, select [+] next to "Add
another home appliance". If you have not added any
Home Connect appliances to your home network yet,
step-by-step instructions for connecting the appli-
ance will appear. Select [Start]. If prompted to, en-
ter the password for your wireless local area network
and select [Next].
c) If the Home Connect app requires connection to be
started on the appliance, briefly press the "Wireless
network" button on your robot vacuum. The button
will flash yellow for confirmation.
iOS: Now select [Next] and connect to "Home Con-
nect" as described there. You will need to enter the
password for your wireless local area network and
confirm by selecting [Next].
Wait until the "Wireless network" button lights up
green and three beeps indicate that connection has
been successful. This may take a few minutes.
Android: Now select [Next].
d) The robot vacuum will connect to the app.
Select [Next].
Set the time function you want in the app and confirm
with [Done].
en