Zipper ZI-ELB70 Manuel D'utilisation page 22

 Risk of noise:
Working for a long time can damage your hearing if you do not use a very good hearing protection.
 Risk to the hands or fingers:
Access while it is working in the mowing apparatus. After the operation, the machine must cool down.
Otherwise, there is an acute risk of scalding!
 Vibration:
The declared vibration emission value has been for a standardized test is measured and can be used to
compare one tool with another electric are.
The declared vibration emission value may also be used for a preliminary assessment of exposure.
Warning:
Emission level of vibration can be different from the specified value during the actual use of the electric
tool, depending on the manner in which the power tool is used. When you feel uncomfortable or notice
discoloration of skin on your hands during the use of the machine, stop working immediately. Observe
sufficient break times to rest. Failure to have sufficient break times may result in a hand-arm vibration
syndrome.
The extent of exposure depending on the type of work or machine use should be estimated and
appropriate breaks taken. In this way, the extent of exposure can be considerably reduced over the
entire work time. Minimize the risk caused by vibrations. Maintain this machine according to the
instructions in the manual.
 Risk of thrown out objects:
When working with earth augers there is a danger that stones and other objects are thrown out with
injury potential by drilling. The risk of injury can be reduced by wearing appropriate safety equipment
but not entirely eliminated. Make sure that other people or animals are not staying within the danger
area.
 Risks of working area:
Ensure yourself that there are neither water or gas pipes nor electric lines installed underground in the
working area.
 Risk of burns:
Touching the mufflers, exhaust and other machine components which can be hot after prolonged
continuous operation or when the engine is hot cause severe burns.
 Risk of fire and explosion:
Gasoline is highly flammable and explosive under certain conditions.
NEVER refuel fuel or engine oil while the machine is in operation or is hot.
When refueling and at places where fuel is stored not smoke or allow open flames or sparks.
Do not overfill the fuel tank and avoid the spillage of gasoline during refueling. If fuel is spilled make
sure the area is completely dry and cleaned before starting the engine.
Make sure that the filler cap is tightly closed again after refueling safely.
 Chemical risks:
Never use or refuel a gasoline or diesel engine in a closed area without adequate ventilation.
Carbon monoxide emissions from the internal drive units of the engine can cause in confined spaces
through inhalation health effects and death. Therefore use the machine only in well-ventilated rooms or
outdoors in operation.
Liquid fuels can cause serious damage on the skin and the environment.
 Risk of kickback
Through sudden blocking of the drill, it may, until the slip clutch begins to come to a sudden twist of
the body.
These risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge and
experience.
In spite of all safety is and remains her healthy common sense and their corresponding technical
qualification / training for use of the machines most important safety factor!
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-ELB70 22
22