Storage; Disposal - Zipper ZI-ELB70 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27

15.2.4 Storage

If you store the machine longer than 30 days:
Allow the engine to cool down before storing the machine
Drain fuel from fuel tank and carburettor and store the fuel in a suitable container.
Store the unused machine in a dry place out of the reach of children.

15.2.5 Disposal

Do not dispose the machine, machine components fuel and oil in residual waste. Contact
your local authorities for information regarding the available disposal options. When you
buy at your local dealer for a replacement unit, the latter is obliged to exchange your
old.
16
TROUBLE SHOOTING
Trouble
Engine does not start
Engine starts and is stalled
immediately
Machine works with interruptions
Smoke
Machine does not work with full
performance
Drill rotates at idling
Drill rotates but has no power
Drill jumps
Should you in necessary repairs not able to properly to perform or you have not
the prescribed training for it always attract a workshop to fix the problem.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-ELB70
26
Possible cause
 Incorrect starting sequence
 Dirty air filter
 No fuel supply
 Fault in the fuel line
 Engine flooded.
 Spark plug connector not placed
on.
 No ignition spark
 Incorrect idle adjustment
 Carburetor incorrectly adjusted
 Spark plug fouled
 Incorrect fuel mixture
 Carburetor incorrectly adjusted
 Machine overloaded
 Dirty air filter
 Carburetor incorrectly adjusted
 Idle speed too high
 Choke is ON
 Drill damaged
 Unsuitable, stony soil
N O T I C E
TROUBLE SHOOTING
Solution
 Observe the correct starting
sequence
 Clean/replace air filter
 Refuel
 Check the fuel line for kinks or
damages
 Screw off, clean and dry the
spark plug. Then pull the
cranking rope several times
and reinstall the spark plug
 Place on the spark plug
connector
 Clean/replace spark plug
 Check ignition cable
 Contact customer service
 Contact customer service
 Clean/replace spark plug
 Check spark plug connector
 Use correct fuel mixture
 Contact customer service
 Too much pressure
 soil too tough
 Clean/replace air filter
 Contact customer service
 Adjust a lower idle speed
 Set Choke to OFF
 Replace a new drill
 impossible
26

Publicité

Table des Matières
loading

Table des Matières