Cold Starting; Warm Starting; Stopping The Engine; Operating - Zipper ZI-ELB70 Manuel D'utilisation

14.2.3 Cold starting

1. Put the machine with the drill to the ground. The drill must be moved freely.
2. Put the choke into position ON as shown in (Fig. C).
3. Put the switch (H-3) into position START.
4. Push the fuel pump (I-9) 3-5 times (Fig. K).
5. Press the security lever (H-1) with the heel of your hand.
6. Operate the throttle lever (H-4).
7. Push the locking lever (H-2) in order to block the throttle lever to increased idling.
8. Now grab the bar holder (I-1) and with the other hand the starter handle (I-4) and pull it out
briskly! Repeat if necessary
9. The engine starts with increased idle speed!
10. After engine has started push the throttle lever (H-4) and the locking lever (H-2) will be
unlocked. Now the engine runs in normal idle speed.
11. If the engine runs clear put the choke into position OFF as shown in (Fig. D).
12. Let the engine run in idle speed for 2-3 Minutes!

14.2.4 Warm starting

1. Put the machine with the drill to the ground. The drill must be moved freely.
2. Put the switch (H-3) into position START.
3. Now grab the bar holder (I-1) and with the other hand the starter handle (I-4) and pull it out
briskly! Repeat if necessary.
If the machine does not start after several attempts repeat the procedure as for cold starting.

14.2.5 Stopping the engine

The engine can stopped any time (especially in danger) by releasing the throttle lever and put the
switch (H-3) into STOP position.
We recommend to first lift the drill out of the hole than release the throttle and then to put the switch
(H-3) in position STOP.
Wait until the drill stands still. Now you can put down the machine.
14.3

Operating

• Remove loose objects lying around in the immediate working area. They might be winded up by
the rotating drill and block it.
• Take a safe position and hold the auger firmly on both handles.
• Put the tip of the auger on the ground and start the process carefully and increase gradually the
speed.
• Drill holes without exerting too much body weight on the auger. Allow the auger to advance by its
own weight.
 If the auger drill is jammed in the soil and cannot be pulled out, stop the engine remove the
aggregate, mount the manual crank and turn out the drill counterclockwise.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-ELB70 24
WARNING
Stop the engine immediately in case of imminent danger!
OPERATION
24