Control Joystick Unit Position; Getting Ready To Drive. (Fig.5.11) - Zippie Salsa M2 Mini Manuel D'utilisation

5.6 Control joystick unit position

WARNING!
• Make sure that the control system is mounted
securely and that the joystick position is correct.
• The hand or limb you use to operate the joystick
should be supported, for example by the arm pad.
• Do not use the joystick as the sole support for your
hand or limb - wheelchair movements and bumps
could upset your control.
The remote is mounted on a sliding mechanism which
enables the control to be moved forwards and backwards.
When the most comfortable position has been selected,
secure the slider by tightening the locking screw. (Fig.
5.10, A)
WARNING!
Ensure the locking screw is fully tightened prior to use,
especially when transporting your wheelchair .

5.7 Getting ready to drive. (Fig.5.11).

• Operate the on/off switch, (A).
• The battery gauge will blink then remain on after a
second
• Check that the maximum speed is set to a level which
suits you, (B).
• Push the joystick to control the speed and direction of
the wheelchair , (C).
NOTE: Please refer to Section 7
22
ZIPPIE SALSA M Mini
2
A
A
B
C
Fig.5.10
Fig.5.11
B
Rev.C