Installation Of Appliance; Hydraulic Connections; Gas Connection; Installer's Manual - Beretta Kompakt R.A.I. Manuel D'installation Et D'utilisation

1.

INSTALLATION OF APPLIANCE

The boiler is to be installed by professionally qualified
personnel.
The following Kompakt models are available
Model Type
R.A.I. heating only
R.S.I. heating only
Installation must comply with standards and local legislation
in force.
For proper installation remember the following:
- do not place the boiler above a stove or other cooking
appliance;
- minimum spaces are to be met for maintenance
operations.
The boiler is available with supporting plates.
Act as follows for installation:
- mark 4 holes for fixing the boiler supporting plate
- fix plate onto the wall
- check all measures are correct and drill the wall
- hook the boiler onto the supporting plate.
Make hydraulic connections.
2.

HYDRAULIC CONNECTIONS

Position and dimensions of hydraulic connections are
specified in figure 1.
A CH return
B CH delivery
C

gas connection

3.
Before connecting appliance to gas supply check the
following:
- regulations in force are met
- the gas type is the same as set for the appliance
- pipes are clean.
Gas channelling is provided for externally. If the pipe gets
through the wall,
it must penetrate through the central hole of template lower
part.
It is recommended to install a properly-dimensioned filter
on the gas supply line if the distribution network contains
any solid particle.
After installation, check all junctions performed are tight,
as required by regulations in force about installation.
INSTALLATION OF APPLIANCE
Category Power
B11 BS 14 kW
C 14 kW
3/4"
3/4"
3/4"
GAS CONNECTION
Supporting
plate
C
B
A
Kompakt R.A.I.
Kompakt R.S.I.
Measures in mm
4
Fig. 1
Fig. 2