Conditioning The Flash Capacitor; Factory Settings (Reset) - Metz mecablitz 64 AF-1 digital Mode D'emploi

16.2 Conditioning the flash capacitor

The flash capacitor built into the flash unit
undergoes a physical change when the
device has not been used for a long time.
For this reason it is necessary to switch the
device every three months for approx.
10 mins. The power supplies must deliver
enough power so that flash standby lights up
no later than 1 min after switching on.

16.3 Factory settings (RESET)

The flash unit can be reset to the factory set-
tings when delivered.
Setting procedure
• Press the
for the selection menu to appear.
• Press the
SERVICE
touch display.
SERVICE O
• Press the
BRIGHTNESS
display.
ROTATION
RESET
• Press the
display.
O
RESET
All settings are adopted immediately and
the flash unit is reset to its factory settings.
OFF
ON
This will not affect the firmware updates for
the flash unit !
D
button as often as it takes
SERVICE
sensor button on the
RESET
sensor button on the touch
ON
sensor button on the touch
k
209