Installation Supporting Base; Walls, Columns, Floor And Ceiling Mounting; Operation; Rolling Out/ Pulling The Hose - HOLZMANN MASCHINEN LSR10HQ Mode D'emploi

Despite all the safety devices and remains her good common sense and your appropriate
technical qualification / training on the operation of a machine such as the LSR 10HQ / 15HQ of
the most important safety factor!
13 ASSEMBLY
13.1

Installation Supporting base

When drilling the holes to the proper spacing. The schematic diagram (on page 10) shows the
distances.

13.1.1 Walls, columns, floor and ceiling mounting

The base mount with 4 screws must be securely 10x60mm (better longer) are attached to stable
wall or ceiling.
The use of anchor bolts with appropriate washers or attachment to a component is strongly
recommended.
14

OPERATION

If the hose can be rolled out in full length, not huge move
tear the hose and the
14.1

Rolling out/ pulling the hose

Remove hose to the desired length and can withdraw slowly clicks into place.

If the hose reel does not lock the same again again go out and leave to withdraw slowly.
Repeat the process locked in the desired position until the hose reel.
If the hose is released during the roll up the hose end to uncontrolled fast
take-up
property damaged. Why not let the hose when
end of the hose controlled take-up
HOLZMANN MASCHINEN GmbH
hose-end
reel. Themselves and other people can thereby be injured or
www.holzmann-maschinen.at
NOTE:
Dimensions for drilling
distances.
residual dangerous swirl around
rolling.
reel.
ASSEMBLY
on, as this may
Always lead to the
14
LSR10HQ, LSR15HQ