Front Brake Lining Control; Rear Brake Lining Control - Beta RR 390 2017 Mode D'emploi

3
GB

fRONT BRakE liNiNG CONTROl

In order to verify the wear condition of front
brake is enough to view the pincer from the
bottom, where is possible to glimpse the
brake lining tails which will have to show
a brake of 2 mm in thickness. If the stratum
is lesser let's start replacing them.
Note
Perform the check according to the times
2
shown in the table on page 56.
WARNING
Failure to promptly replace the brake pads
can result in a considerable reduction of
the braking action and in damage to the
brake disc.
It replaced at an authorized service center
Betamotor.

REaR BRakE liNiNG CONTROl

In order to verify the wear condition of rear
brake is enough to view the pincer from the
back side, where is possible to glimpse the
brake lining tails which will have to show
a brake of 2 mm in thickness. If the stratum
is lesser let's start replacing them.
Note
Perform the check according to the times
2
shown in the table on page 56.
WARNING
Failure to promptly replace the brake pads
can result in a considerable reduction of
the braking action and in damage to the
brake disc.
It replaced at an authorized service center
Betamotor.
42