Installation Instructions: Electrical System For Towing Hitch; General Information - Westfalia 313 061 300 107 Instructions De Montage

GB
Installation Instructions
Electrical System for Towing Hitch
Westfalia Order No.:
Area of Application:

General Information:

Before starting work, please read the installation instructions.
The holes drilled must be deburred and then coated with anti-corrosion paint.
The electrical set may only be installed by specially-trained personnel with the battery disconnected.
Please make sure before drilling that there is sufficient clearance behind the trim.
Important: Any electronically stored data (car radio, onboard computer etc.) may be lost.
The electrical socket in this wiring harness is provided with a switch-off contact for the vehicles own
rear fog light as standard equipment. During trailer towing the rear fog light of the pulling vehicle is
inoperative.
Install a rear fog lamp on older trailers if they do not already have one before operating this electrical
equipment with them.
The indicator lamp only flashes when a trailer is hitched to the vehicle. One-time flashing without a
trailer is permitted.
An electrical socket adapter may only be used during trailer towing, and must be removed after trailer
towing is completed!
The German version of these installation instructions shall be applicable in event of any legal
questions.
Subject to modification!
8
313 061 300 107 / 113
Mercedes Benz 200-300 C, D, E (W124)
7/13-pin