Table des Matières
Publicité
Using the timer
Setting Item
OFF: Timer does not operate.
SETTING
ON: Timer operates.
REPEAT
ONCE: Recording or playback is
performed just once.
DAILY: Recording or playback is
performed daily.
SELECT: Recording or playback is
performed every week on the selected
day.
Press +, – to select the day and use
1
[q OK] to add a check mark. (Press
[q OK] again to clear the selection.)
When the day is selected, select "OK"
2
and press [q OK].
Set the start time and end time
TIME
1
Select the item (select the start hour,
minutes, end hour, minutes) using u,
i and set using +, –.
• Up to 12 hours can be set for the period
from start time until end time.
REC/PLAY
PLAY: Plays a set file, or plays the alarm
sound.
REC: Records the set sound source.
56
56
Details
Setting Item
ALARM: Plays the alarm sound.
PLAY
2
FILE: Plays a file.
The file list of the folder being selected is
displayed.
Press +, – to select the file and press
[q OK]. When selecting files by switching
folders, press u and you can move
within hierarchies. (For details of file and
folder selection methods, see page 13.)
SOURCE
MIC: Microphone recording.
3
LINE: Records sound from an external
device.
MODE
PCM 44.1kHz, MP3 320kbps,
3
MP3 192kbps, MP3 128kbps,
MP3 64kbps, MP3 32kbps
REC TO
Select the folder in which to save the
3
recorded file.
• If an SD card folder is selected, insert
the SD card.
When setting the start time and end time, do not mix
1
up a.m. and p.m.
AM12:00 and PM12:00 represent 0:00 a.m. and noon
respectively. When performing timer recording at 0:00
a.m., set the start time to "AM12:00".
Displayed when "PLAY" is selected for "REC/PLAY".
2
Displayed when "REC" is selected for "REC/PLAY".
3
Details
Publicité
Table des Matières
