Abus FUMK50000W/B Instructions D'installation Et D'utilisation page 16

FUMK50000W/B
5. Device description
LK1
LK3
LK2
LK4
6. Signal LED
Operating status
Operation mode
Transmit / program mode IR
Program mode detector intern
Activating the LED
Attach a jumper to contacts LK1 and LK3. Short-circuit the LK4
contact with a jumper until the LED flashes continuously. Re-
move this again. The LED is now activated. Restore the original
position of the jumper.
Deactivating the LED
Attach a jumper to contact LK1. Short-circuit the LK4 contact
with a jumper until the LED flashes continuously. Remove this
again. The LED is now deactivated. Restore the original position
of the jumper.
16 | E N
Operation mode of exter-
nal contacts
Internal Contact
Programmierung
1 Fixing screw
2 Jumper connection LK4
Jumper connection LK2
3 Magnet switch
4 Jumper connection LK3
Jumper connection LK1
5 Battery
6 Screw clamp block
7 Tamper protection, cover
8 LED
Signal
No signal
4 x flashing
flashing