Abus FUMK50000W/B Instructions D'installation Et D'utilisation page 15

Interface
Fe
Fe
4. Training the detector (Zone 1)
Ensure that the Secvest (receiver) is in learning mode. Keep the
anti-removal wall contact pressed. When deinstalled, also keep
the cover contact pressed. Open one of these contacts until suc-
cessful reception is confirmed (double tone).
Using a wireless extension (wireless accessory module), hold
the signal LED of the detector at a maximum of 50 mm above
the IR receiver. Train the zones as described below.
The possible configurations of the individual
zones can be found on the previous pages. You
can also use this wireless magnet contact as a
wireless module.
E N | 15