Selecting A Program - Beurer EM 29 Mode D'emploi

Masquer les pouces Voir aussi pour EM 29:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
switched on for the first time, program A is automatically
activated.

Selecting a program

Press the program button P [3] to switch between the pro-
grams.
The following programs are available:
Program
Frequency
A
4 Hz – 110 Hz (3 phases)
B
4 Hz
C
2 Hz (burst)
D
100 Hz
Note:
With program A, you will feel the effect become
stronger when the program changes from phase 1
to phase 2 (after approx. 10 minutes). This is normal
and intentional. If the intensity seems too high, you
can lower it by simply pressing the intensity button
▼ [2].
Note:
If the program is changed during stimulation (for ex-
ample from A to B), the output intensity will increase
gradually in the new program until it reaches the in-
tensity that was previously set. This can be stopped
if required by pressing and holding the intensity button ▼
[2] for two seconds or by switching off the device by press-
ing and holding the On/Off button [1] for two seconds.
Stopping pulses that are too strong
You can lower the intensity at any time or turn the de-
vice off by pressing and holding the On/Off button [1]
(~ 2 seconds).
Time
Setting the intensity
30 min
Press the intensity button ▲ [2] to gradually increase the
25 min
intensity or the intensity button ▼ [2] to lower the intensity.
There are 20 levels of intensity that can be selected. De-
25 min
pending on the intensity level, you will start to feel tingling,
25 min
which may increase up to muscle contractions.
Select a setting that is comfortable for you during
use.
Preventing unwanted pulse changes
To prevent unintentional increases in intensity during a
treatment, simply switch the button lock on. To do this,
press and hold the program selection button P [3] for ap-
prox. 2 seconds. An acoustic signal sounds and the sym-
bol "
" appears in the display [6]. To release the button
lock, press and hold the P button [3] for approx. 2 seconds.
Reacting to unpleasant sensations
If you feel a twinge or itching on your skin, you should
switch the device off and proceed as follows:
25

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Tens em 29

Table des Matières