Selecting Temperature; Fast Heating; Cleaning And Care - Beurer HK Comfort Mode D'emploi

3.3 Selecting temperature

The fastest way to heat up the heating pad is to first set the switch to the highest setting. A
lower setting can be selected later if required.
After switching on the heating pad, the setting starts flashing briefly, while the heating pad
conducts a self-test. Then the setting remains illuminated continuously.
We recommend the lowest temperature setting for extended use of the heating pad.
3.4 Temperature settings
Setting: 0
1
2
3
3.5 Automatic switch-off function
These heating pads have an automatic switchoff function which stops the heat
supply approx. 90 minutes after switching on the pad. The illuminated function
display then starts to flash. To operate the heating pad again, you must first set the
switch to zero. After about 5 seconds, it can be switched on again.
If the heating pad is no longer used after the timed switch-off, it should be switched
off (setting "0") or else unplugged from the mains.

3.6 Fast heating

These heating pads have a fast heating function which allows them to heat up quickly
within the first 10 minutes.

4. Cleaning and Care

Before cleaning the heating pad, always unplug it from the mains.
Do not use any cleaning agents containing solvents on the appliance.
Please note that the heating pad should not be dry-cleaned, wrung out,
machine-dried, pressed or ironed.
Before washing, first remove the plug-in connection together with the
switch from the heating pad (see illustration). Set the washing machine to a gentle washing
cycle at 30°C.
For ecological reasons, we recommend that the heating pad is only washed together with
other textiles. Use a washing powder or liquid for delicate fabrics and dose it according to the
manufacturers instructions.
Please note that excessive washing will wear out the heating pad. For this reason, the heating
pad should only be machine-washed a maximum of 10 times throughout its entire life.
When drying the heating pad, do not use clothes pegs or anything similar, and never
switch the heating pad on to dry it!
Do not reconnect the switch to the heating pad until the plug-in connection and the hea-
ting pad are completely dry.
5. Storage
If you are not going to use the heating pad for some time, we recommend storing it in its original
packaging in a dry place without weighing it down. To avoid breaking the heating pad, do not
place any objects on top of it whilst storing. Allow the heating pad to cool down beforehand.
Off
Minimum heat
Medium heat
Maximum heat
9
90
min
STOP