Troubleshooting - Tascam DR-70D Mode D'emploi

Troubleshooting

If you are having trouble with the operation of this unit, please try the following
before seeking repair. If these measures do not solve the problem, please contact
the store where you bought the unit or TEAC customer support (see back page).
8 The unit will not turn on.
•
Confirm that the batteries are not dead.
•
Confirm that the batteries are installed with the correct ¥/^ orientation.
•
Confirm that the AC adapter (TASCAM PS-P515U, sold separately) is securely
connected to both the outlet and the unit.
•
When using USB bus power, confirm that the USB cable is securely connected.
•
When using USB bus power, confirm that it is not connected via a USB hub.
8 The unit turns off automatically.
Is the automatic power saving function on? (See "Setting the automatic power
saving function" in "Settings and Information" of the Reference Manual.)
i Since this unit complies with the European Standby Power Regulations (ErP),
the automatic power saving function operates regardless of whether the unit
is being powered by an AC adapter or batteries. If you do not want to use the
automatic power saving function, set it to "OFF". (The factory default setting is
"30min".)
8 The unit does not function.
•
Confirm that the HOLD/ switch is not set to HOLD.
•
Is the unit connected to a computer by a USB cable? (Does "USB connected"
appear on the display?)
8 The SD card is not recognized.
•
Confirm that the SD card is inserted completely.
8 Playback is not possible.
•
If you are trying to play a WAV file, confirm that the sampling frequency is
supported by this unit.
20
TASCAM DR-70D
8 No sound is output.
•
Check the connections with the monitoring system.
•
Is the volume of the monitoring system minimized?
•
Is the output level setting of the unit minimized?
8 Recording is not possible.
•
Check connections with other equipment again.
•
Check the input settings again.
•
Confirm that the input level is not too low.
•
Confirm that the SD card is not full.
•
Confirm that the number of files has not reached the maximum that the unit
can handle.
8 The input level is low.
•
Confirm that the input level setting is not too low.
•
Confirm that the output level of any connected device is not too low.
8 The sound I am trying to record sounds distorted.
•
Confirm that the input level setting is not too high.
8 Adjust the input knobs so that the PEAK indicators do
not light.
•
Lower the volumes of the sound sources being input to this unit.
8 I cannot erase a file.
•
Confirm that you are not trying to erase a file that has been copied from a
computer after being write-protected.
8 This unit's files do not appear on the computer.
•
Confirm that the unit is connected to the computer using its USB port.
•
Confirm that no USB hub is being used.
•
Confirm that the unit is not recording.