OCULUS BIOM ready Mode D'emploi page 18

BIOM® ready
Instructions for Use
Caution
Risk of eye damage if the working distance between the
BIOM® ready and the patient changes.
When the BIOM® ready is swung into the working position
(into the beam path), the following instructions must be
followed:

Do not use the coarse adjustment knob at the
microscope stand to adjust the height.
 Do not adjust the height of the stand arm, either by
motor or manually, over the surgical area.

Do not change the patient's position by adjusting the
height of the OR- table.
Risk to the patient as a result of uncontrolled head
movements of the patient.

Take suitable measures to prevent uncontrolled head
movements of the patient during the surgical
procedure.

Avoid any contact of the front lens with the cornea.
If the lens touches the cornea, the image will become blurred immediately.

In an extreme emergency, e.g. uncontrolled downward movement of the
microscope:
 Stop by pressing the Emergency Off button.

Pull / move the complete surgical microscope upwards.
 Swing the BIOM® ready out of the beam path.

If contact with the eye has occurred: Swing out the BIOM® ready, or lift the bottom
part of the BIOM® ready to make it easier to clean the optics, so that you can clean
the lens with a sterile swab.
Clean the front lens with care, as it can easily break off.

Make sure that the cornea is adequately wetted with a suitable solution. This
prevents damage to the cornea and ensures optimal observation.
en Instruction Manual
Focusing Instructions
You can manually focus the BIOM® ready with the focusing knob.
Heed the following points when focusing with the BIOM® ready:
 The BIOM® ready is only needed for visualization of the posterior eye section.

After performing the surgical steps at the front section and outside of the eye, leave
the microscope at this position (height).

Before swinging it into the working position, make sure that the BIOM® ready has
been set to the shortest length.

Before beginning the focusing process, check the distance from the front lens to the
patient's eye.

Monitor the distance from the front lens to the patient's eye during the focusing
process.

Avoid the front lens from coming into contact with the patient's eye.

While focusing with the BIOM® ready, make sure that
 The working height of the microscope is not adjusted.
 The focusing function of the microscope is not used.
G/54413/0718/in 18