Operation With The Sprinkler Attachment; Work Interruptions; Working With Plant Protection Products / Cleaning Agents (Accessory); Decommissioning And Storage - Gloria MULTIJET Mode D'emploi

NOTE!

Make sure that the water tap is fully
turned up!

Ensure that you are standing firmly since
the water jet can produce a greater or
lesser degree of recoil force at the device
(depending on the operating mode that
was selected). Always hold the spray
gun and spray pipe firmly with both
hands.

Make sure that the surface to be
cleaned is free from debris such as
stones, screws etc., which could be
flung up.

Ensure that the high-pressure washer is
on level ground.

Do not move the high-pressure washer
by pulling the hose, this could cause the
machine to become unstable and fall
over.

Do not kink or drive a motor vehicle
over the high-pressure hose. Do not
expose the high pressure hose to sharp
edges or corners.
6.4.3 Operation with the sprinkler
attachment
- Attach the sprinkler (K) for plant
15 16
and garden irrigationand start
watering.
= Sprinkler
Combine the set pressure with the sprin-
kler (K). We recommend the following
settings, for example:
+ = Watering plants

6.4.4 Work interruptions

If you need to stop working, release the
17
trigger (M) on the spray gun (P) and lock
the trigger (M).
This will switch off the pump in the
remain ready for operation.

To switch on the
again, unlock and then press the trigger
(M) on the spray gun (P). The device will
continue operating in the most recently
selected setting.
but the device will
28
6.5 Working with plant protection
products / cleaning agents (accessory)
GLORIA offers various accessories for the
tion and more intensive care. Information
on these is given in section 10 "Acces-
sories / spare parts".
7 Decommissioning & Storage

7.1 Decommissioning

-
Figures
18 21
DANGER
DANGER OF ELECTRIC SHOCK!
Before decommissioning and stor-
age, pull out the mains plug!
CAUTION
RISK OF INJURY FROM RESIDUAL
PRESSURE IN THE
Disconnect the high pressure hose only
from the spray gun or the device when
no pressure exists in the system.
Decommission
18
main switch for power supply (V) on
the device. Once you have switched
off the
will still be pressure in the pressure
hose. To depressurise the system,
turn off the tap on the water supply
line and press the trigger (M) on the
spray gun (P) until no more water
comes out of the sprinkler.
19 When the system is depressurized,
disconnect the pressure hose (I)
from the spray gun (P) by pressing
the release button (Q) at the spray
gun and pulling off the pressure
hose.
20 To do this, disconnect the pressure
hose (I) from the device by pulling
up the release (Y) on the device and
pulling off the pressure hose.
When the system is depressurized,
21
disconnect the intake hose (H) from
the device and from the water sup-
ply line.
for plant protec-
HOSE PIPES!
the
by pressing the
, there