Güde GBM 130 Traduction Du Mode D'emploi D'origine page 33

Failure removal
Failures
Engine does not start
Engine growling, running but not
starting
Equipment starting but getting
blocked under small load and
switching automatically off
The contact pressure of the hand
wheel is too loose
Drum not rotating after starting the
machine
Causes
No power supply.
Broken cable
Gear ring blocked
Defective condenser
The extension cable is too long or
with a small cross section
The socket is too far from the main
line and the extension cable has a
small cross section
The pressure spring is not sufficiently
tight
Defective V-belt or mismatching
voltage
Removal
Check the voltage. Technical data
given on the type label must corre-
spond with electric network voltage.
Any checks or replacements to be
provided by a professional electrician
Switch the machine off, unplug it
and clean it or replace the ring gear
components.
Deliver the machine to the customer
service centre for repair
Extension cable to be at least 1.5
mm2 for a length of up to 25 m
Cross section of at least 2.5 mm2 for
longer cables
Tighten the screw on the pressure
spring
V-belt replacement
ENGLISH
33