Installing The Rear Speakers - Yamaha AV-S77 Mode D'emploi

Installing the Rear Speakers

I To mount the rear speakers on a
wall using the provided mounting
brackets (type A)
Use the provided mounting brackets (type A) when hanging
the rear speakers on a wall.
• When hanging the rear speakers on a wall, be sure to
connect the speaker cable to the rear speakers
beforehand. It is difficult to connect the rear speaker
cable after hanging. For details of the speaker cable
connection, refer to page 18.
1
Attach two commercially available protruding
screws (diameter about 4 mm) in the location
on the wall where the rear speaker is to be
hung, and then mount the bracket on the
protruding screws.
Check that the screws are secure inside the narrow
portion of the holes in the bracket.
20 mm or more
Mounting bracket
(type A) (provided)
2
Attach the speaker to the bracket using the
provided wing nut.
3
Adjust the angle of the speaker and then
tighten the wing nut.
65 mm
Wing nut (provided)
I To mount speakers directly to the
wall
It is possible to hang the speakers directly on the wall
without using the mounting brackets by attaching two
protruding screws to the wall and then using the holes on
the rear panel of the speakers for direct attachment.
Protruding screws of about
4 to 5 mm in diameter
(commercially available)
70 mm 70 mm
7 mm
20 mm or more
Note
• After mounting, check that the speakers are attached securely.
I YAMAHA speaker stand SPS-AV1
(sold separately)
The rear speakers can also be attached to SPS-AV1 speaker
stands and used as floor stand speakers.
INSTALLATION
9
E-