Yamaha AV-S77 Mode D'emploi page 12

INSTALLATION
I To mount the rear speakers on the
commercially available speaker
stands
The provided mounting brackets (type B) with 1 pair of
screw holes (at an interval of 60 mm) can be used to mount
the rear speakers on the commercially available speaker
stands.
• Also refer to the instructions manual for the speaker
stands.
1
Attach the mounting bracket (type B) to the
bottom of the speaker using the provided
screw.
Align so that the protrusion on the bracket goes into the
groove on the bottom of the speaker.
Mounting bracket
(type B) (provided)
2
Mount the speaker on the speaker stand using
the bracket holes.
Be sure to prepare small screws (diameter: 4 mm,
length: 8 mm), spring washers and washers.
60 mm
10
E-
Screw (provided)
CAUTION
Be sure to read these important precautions.
• Each speaker weighs approximately 0.8 kg. Select a
firm wall or pillar to attach screws to. Do not attach
screws to material such as mortar or veneer as screws
may come loose easily, causing the speaker to fall.
• Do not mount speakers using nails or tape as
vibrations during operation may cause nails to come
loose or tape to peel off, causing the speaker to fall.
• Take care that the speaker cable is not pinched
between the speaker and the bracket. Be sure that the
speaker cable passes through the groove on the rear
panel of the speaker.
• Secure the speaker cables so that they will not catch on
hands or feet, causing speakers to fall.
• Be absolutely sure to check for safety after speakers
are mounted. YAMAHA bears no responsibility for
damage caused due to improper installation or
installation in an improper location.