After Use - tomado TWC3701W Mode D'emploi

I nstruction: When the battery is almost empty, the indicator led starts to flash slowly. After some time, the appliance
switches off completely when the battery is empty. Charge the battery.
9 Press the on/off button ( ) to switch off the glass cleaner. Always switch off the appliance when spraying a surface
to extend the usage time of the battery.
Cleaning windows, mirrors or tiles is also possible without using the spray bottle. Clean your windows in the usual way
and use the glass cleaner to absorb the cleaning agent and clean your windows without leaving any streaks.
EMPTYING THE COLLECTION RESERVOIR
10 Empty the collection reservoir once the amount of dirty water has reached the maximum indication. Switch off
the appliance. Open the lip 1 and allow the collection reservoir to empty.
11 Once the collection reservoir is empty, press the lip closed again.
Press the on/off button ( ) to switch off the glass cleaner.
12 The glass cleaner contains electrical components. Do not clean the appliance itself under the tap. Press push button 1 to
release the squeegee attachment 2.
The squeegee attachment can be cleaned under the tap.
• Remove the microfibre cloth from the holder and rinse it under the tap. The microfibre cloth can be washed in the washing
machine at 30 ᵒC. Do not use a fabric softener.
• The basis of the glass cleaner may be wiped with a damp cloth.
13 Empty and clean the collection reservoir after using it a couple of times. Press down the lip 1 of the collection reservoir
and remove the reservoir 2 from the basis.
14 Open the collection reservoir by pulling the upper and lower halves away from each other. Carefully remove the internal
component from the lower half of the reservoir. Now clean the inside of the reservoir under the tap or by means of a damp
cloth. (Caution: The components of the glass cleaner should NOT be washed in the dishwasher!)
15 Place the internal component back in the lower half of the reservoir. Click both halves of the reservoir together and place
the reservoir 2 back in the basis. Check that the lip 1 clicks and is fastened.
• Allow all components to dry properly before reassembling the appliance.
• Charge the battery so that the appliance is ready for its next use. After charging, remove the charger from the socket.
• Store the appliance upright in a dry room.
LICHTS CONTINUOUSLY (motor is on)
FLASHES SLOWLY (motor is on)
FLASHES QUICKLY (motor is off)
FLASHES SLOWLY (during charging)
LIGHTS UP CONTINUOUSLY (during charging)
FLASHES QUICKLY

AFTER USE

INDICATOR LED
The appliance is working normally
Battery is running empty (less than 5% capacity remaining)
Battery empty
Battery is being charged
Battery is fully charged
Safeguard against overloading activated (motor uses too
much power, e.g. due to a blocked ventilation opening
or when the collection reservoir is placed incorrectly).
EN - 17