1.
Handle
2. Hose connection
3.
Dust bag full indicator
4. Suction power controller MIN - MAX
5. On/off switch
6. HEPA filter under the grille
7. Cord winding system
8. Button for automatic cord winding
9.
Hose
10. Extra suction power controller
11. Telescopic tube - inner
12. Slide button to adjust tube length
13. Accessory holder
14. Telescopic tube - outer
15. Floor nozzle with button for retracting and extending the brushes
16. Handle of dust bag compartment cover
17. Brush nozzle
18. Crack nozzle
19. HEPA13 filter
20. Motor filter
21. Holder for motor filter
Follow these instructions when using the vacuum cleaner for the first time: Carefully remove the vacuum cleaner and
all accessories from the packaging and remove all packaging material. Keep the packaging (plastic bags and cardboard)
out of reach of children. After unpacking the appliance, carefully check it for external damage that may have occurred
during transport. Place the vacuum cleaner on a sturdy, dry and flat surface.
Make sure the plug of the vacuum cleaner is not inserted in a socket when (dis)assembling accessories or parts.
HOSE
Connecting the hose to the vacuum cleaner: insert the end of the hose in the hose connection on the vacuum cleaner and turn
it clockwise with a firm twist until you hear a click sound - fig. 1.
Disconnecting the hose from the vacuum cleaner: check that the plug is not in a power socket. Turn the end of the hose
counter-clockwise to disconnect it from the vacuum cleaner.
TELESCOPIC TUBE
1. Insert the handle of the hose in the telescopic tube - fig. 2A.
2. Attach the floor nozzle by sliding the tube firmly into the floor nozzle - fig. 3A.
3. Adjust the telescopic tube to the required length. Slide the button at the top of the tube upwards and pull the lower section
of the tube to make it longer - fig. 4. When you let go of the sliding button, the tube will snap tight at the required length.
PRODUCT DESCRIPTION
PRIOR TO FIRST USE
ASSEMBLY
EN - 16
/